SlopedPlanesMacro

damian · Post by **damian** » Mon Nov 13, 2017 7:17 am

Good morning Community
Today I'll show you my progress with the tool SlopedPlanes.

damian · Post by **damian** » Mon Nov 13, 2017 7:43 am

Simple figures

And yes, this is a simple extrusion but the user can select a different extrusion direction or angle for every plane.

damian · Post by **damian** » Mon Nov 13, 2017 5:45 pm

A figure could have several wires and faces. The limit is the FaceMaker.

damian · Post by **damian** » Mon Nov 13, 2017 6:14 pm

The tool has options: Up, Down, Symmetry, Solid, Reverse, Complement, Tolerance y FaceMaker

The angles are controlled from the TaskPanel

damian · Post by **damian** » Mon Nov 13, 2017 6:54 pm

The figures could have reflex corner

DeepSOIC · Post by **DeepSOIC** » Mon Nov 13, 2017 7:06 pm

Looks very cool. I saw you were working with curves as well. Does it support curves?

microelly2 · Post by **microelly2** » Mon Nov 13, 2017 7:12 pm

very interesting for geodata LOD roof design

damian · Post by **damian** » Mon Nov 13, 2017 7:36 pm

The two planes involved in a reflex corner act "like a dam". They block the progress of other planes.

damian · Post by **damian** » Mon Nov 13, 2017 7:48 pm

One edge could grow two faces

damian · Post by **damian** » Mon Nov 13, 2017 8:37 pm

DeepSOIC wrote: ↑Mon Nov 13, 2017 7:06 pm Does it support curves?

Today no. Soon!
Now I found a mistake and I can't continue with the exposition. The problems of the direct.
The next week more
Thanks to everybody