While this is not a complex Project according the FreeCAD modelling, I want to show it here. That is because I got lots of help from the nice community here and I really like FreeCAD and all the affort that is put into it.
So thanks again, for this great free Software! I used Ubuntu 18.10 which fits perfectly togehter with FreeCAD
Of course everyone can use the design, as long as he does not claim it would be his design and names where it is from!
As my first project in FreeCAD, I made parts to build a big enclosure for my 3d Printer. I first wanted to use the Ikea Lack Enclosure, that are often found on the net. But they are to small and I want it rather big than pretty.
It is in my cellar, so it must not be very pretty - just usefull.
Big Enclosure for 3d Printer
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
Big Enclosure for 3d Printer
- Attachments
-
- magnet_holder_for_plexiglass.fcstd
- (38.9 KiB) Downloaded 43 times
-
- spacer.fcstd
- (11.72 KiB) Downloaded 42 times
-
- enclosure_open_lowq.jpg (496.66 KiB) Viewed 1498 times
-
- enclosure_complete_lowq.jpg (484.86 KiB) Viewed 1498 times
-
- enclosure_closed_lowq.jpg (507.59 KiB) Viewed 1498 times
Re: Big Enclosure for 3d Printer
Seems that I can not add all the files, so here are the next ones.
- Attachments
-
- holder_lower_right.fcstd
- (133.01 KiB) Downloaded 45 times
-
- holder_lower_left.fcstd
- (163.81 KiB) Downloaded 41 times
-
- holder_left_side.fcstd
- (85.37 KiB) Downloaded 38 times