un1corn wrote: ↑
Fri Aug 16, 2019 2:33 pm
Horizontal 4 cylinder rotary valve steam engine.
I have included your image in the Release_notes_0.19
just to have something there while we pick the final images that will be included in the release notes. Ideally it would be an image that was built with the 0.19 development version so we can say we are showcasing this version and not some old version.
It seems most of your models were made with FreeCAD 0.16, and then they were assembled with A2plus.
Could you say that this model would work the same in 0.19? Because if it does, then we can say it was created with 0.19 as well.
If you think this model is not good enough, then would you provide another model?
I have also included the S&S steam engine
from your other thread. But same situation, it seems it was created in 0.16.
Ideally some information on how it was created would be ideal, for example: it consists of 100 objects, created with PartDesign, with colors assigned to each Body, put together in A2plus, and using the Fasteners workbench for the bolts.