Re information requested
I started this model on 7th July 2019 and completed the assembly on 20th October.
There are 723 individual parts + 20 sub-assemblies + several calculation sheets, template models for LH/RH parts and inner formers where the thickness and or extrude tool would not cope.
I am using FreeCad V0.18, parts created mostly in PartDesign and Sketcher WB's and assembled with A2plus Workbench
Items such as the spoke and spud screws and rivets were generated where possible as an array in Draft WB which made it easier to import and position in the assembly.
The source of these and the greater majority of the model plans of the images I have posted were sourced here:- http://www.vapeuretmodelesavapeur.com/telechargements4/
courtesy of JDW Draughting services, 12 Brightwell Street, Papakura, New Zealand.
Julian De Waal is very helpful if you need to contact him with any questions.
Bear in mind that as I am now 76, well and truly retired, have some mobility issues and have been widowed for close to 10 years, I have plenty of time to devote to these model, I wish I was still in the position to physically make them.
I have attached a PDF sheet showing the details of my PC etc.
I hope this answers most of the questions raised.