Shaper Tool Assembly

[MrCAD]

Done with A2Plus.

However, faced some error at couple of parts due to dimensional errors and first time ever try the speed modelling with FC which may lead to unsolved constrained but I guess it is my first try with Assembly and like to give a shot.

Sometimes I am confused between A2plus and Assembly 4 workbench but found some interesting stuff on A2Plus, thus modelled with the same.

Assly.jpg (22.74 KiB) Viewed 776 times

Assembly.jpg (51.99 KiB) Viewed 776 times

[un1corn]

I remember the shaper head tool holder from when I was an apprentice in the 60's
Nice job.