Hello all ,
This is a T slot plate for a CNC machine I am designing. I know this is not to much but It was a little difficult for me give all the constraint for the slots because my PC freezing and haging when I was doing . I think it have not enough RAM memory.
Regards.
Uploaded with ImageShack.us
T slot plate for a CNC machine
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
-
- Posts: 113
- Joined: Sat May 21, 2011 12:11 pm
Re: Show your FreeCAD projects here!
Hello aguseguedre,
Even on recent hardware, the sketcher can be quite slow with large sketches.
I always break down designs in small chunks. Here's how I would have modeled your design:
Even on recent hardware, the sketcher can be quite slow with large sketches.
I always break down designs in small chunks. Here's how I would have modeled your design:
- Pad a simple plate
- Pocket a single slot
- create a linear pattern feature with the pocket
-
- Posts: 113
- Joined: Sat May 21, 2011 12:11 pm
Re: Show your FreeCAD projects here!
Hello Norman,
Thanks for comment. When I started I did one slot and I pocket it but I do not knew how to do the next step. I will tried.
Regards.
Thanks for comment. When I started I did one slot and I pocket it but I do not knew how to do the next step. I will tried.
Regards.