Hi
How to draw a curved ramp? My first attempt with helix and boolean operators was quite a lot of work. Is there an easier way?
Regards
Curved ramp
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Curved ramp
- Attachments
-
- CurvedRamp.FCStd
- (41.13 KiB) Downloaded 28 times
Last edited by pogomad on Thu Dec 02, 2021 1:16 pm, edited 1 time in total.
- thomas-neemann
- Veteran
- Posts: 11939
- Joined: Wed Jan 22, 2020 6:03 pm
- Location: Osnabrück DE 🇩🇪
- Contact:
Re: Curved ramp
Last edited by thomas-neemann on Thu Dec 02, 2021 12:03 pm, edited 1 time in total.
- papyblaise
- Veteran
- Posts: 8011
- Joined: Thu Jun 13, 2019 4:28 pm
- Location: France
Re: Curved ramp
you do a helix and cut it with a rectangle thruAll and symetric
- Attachments
-
- rampe.PNG (3.38 KiB) Viewed 1512 times
-
- rampe.FCStd
- (35.5 KiB) Downloaded 24 times
-
- Veteran
- Posts: 3157
- Joined: Sat May 20, 2017 12:06 pm
- Location: Germany
Re: Curved ramp
Fast example with blendcurves (yellow, Curves-wb) and Surface-wb (the ramp itself).
The blendcurves are attached to the cubes. Adjust blendcurves via data-tab.
The blendcurves are attached to the cubes. Adjust blendcurves via data-tab.
Re: Curved ramp
Hello, greetings to the Community!
The example * .gif (very modular) modeled with "Part" can be done, obviously, with "Part Design", however we do it we can check the parameters using a spreadsheet and dynamically see the result.
The example * .gif (very modular) modeled with "Part" can be done, obviously, with "Part Design", however we do it we can check the parameters using a spreadsheet and dynamically see the result.
- Attachments
-
- Curved ramp.FCStd
- (14.93 KiB) Downloaded 25 times
-
- Rampa_Curva_editable.gif (579.75 KiB) Viewed 1464 times
Re: Curved ramp
You see that it is not possible in a much easier way. In your model you shouldn't use a sketch in a body; move it out with the mouse and remove the body. That makes your model slightly simpler.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Curved ramp
Hi
Thanks! Many solutions, will try them all to find the best one for me.
Regards
Thanks! Many solutions, will try them all to find the best one for me.
Regards