[SOLVED] - Sketch origin won't match part origin

[bambuko]

I am confused...
about your Edge4

Me too, FC won't highlight the selection and I'm not sure which line I originally selected.

It does highlight it both in Master and Linkstage3
but it is a bit crappy colour choice (slightly darker green against light green for fully constrained lines) in Master
blink and you will miss it

Screenshot from 2022-05-29 08.51.24.png (83.86 KiB) Viewed 331 times

It is slightly better in Linkstage3 (violet against light blue for fully constrained lines) plus I know how to customise the colours in this one if I have a problem

Screenshot from 2022-05-29 08.52.16.png (134.04 KiB) Viewed 331 times

[Lonfor]

It does highlight it both in Master and Linkstage3
but it is a bit crappy colour choice (slightly darker green against light green for fully constrained lines) in Master
blink and you will miss it

You taught me something new. It is much appreciated.

[bambuko]

It is much appreciated.

thumb_up.jpg (13.4 KiB) Viewed 224 times