Hello.
Over the past few weeks I have been quite busy filling the wiki with entries for commands (thanks renatorivo for your help).
While examining the snap modes I found something odd, since not finding anything on the bug tracker or in the forum i thought i ask ...
> Running FreeCAD 0.16.6651 on Windows 7 64-bit. WIndows and FreeCAD set to german ...
> Running FreeCAD 0.16.6668 on Linux Mint 17. Linux Mint and FreeCAD set to german (btw: native install via dual boot)
Task:
> Open FreeCAD, create new (empty) document
> go to draft workbench
> select line tool and draw two lines intersecting each other
> we want to draw a third line starting at the intersection point
Windows:
- all snaps but "intersection" turned off
We need to press CTRL to make the intersection snap work
- all snaps but "nearest" turned off
Everything works as expected, intersection found instantly
Linux
- all snaps but "intersection" turned off
Everything works as expected, intersection found instantly
- all snaps but "nearest" turned off
No way ... I found no combination to make "nearest snap" find the intersection ... only the line itself was recognized ...
I am not a programmer (at least not a good one) so no offense intended, but i would at least expect a consistent behaviour
on both OSes.
Or is that special to Linux/Windows and can't be "harmonized" ?
Thanks for taking time and looking into this.
Much appreciated ...
Roland