OK thanks that shows my limited knowledge of technical drawing! Trimetric does what I want it to do.
I have another question. I want to delete the pocket at the bottom but keep the top/bottom through pocket. I have tried various ways to do this but alas do not succeed. I have taken out the chamfer and (temporarily) reduced the length of the top/bottom through hole so the bottom pocket has nothing depending on it but when I delete it seems to affect the other pockets. Please see the 2 attached drawings. Any ideas, or do I have to start again?
Rotate Isometric projection?
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Re: Rotate Isometric projection?
- Attachments
-
- Manifold chamfer b.FCStd
- (33.01 KiB) Downloaded 17 times
-
- Manifold chamfer a.FCStd
- (35.29 KiB) Downloaded 16 times
Maavhamt
[/size]