Hi,
I just started to use Freecad and could you please tell me where it goes wrong.
I was searching forum for answer but no luck.
FCStd drawing is good, but when i export it to Step or Stl files it is nothing like it should be.
You see the problem on this pic
Best Regards
Hans
Problem
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Problem
- Attachments
-
- problem.jpg (110.69 KiB) Viewed 421 times
-
- Posts: 261
- Joined: Wed Jul 23, 2014 10:10 am
Re: Problem
While exporting select ONLY resulting parts, not all of them.