DeepSOIC wrote: ↑
Sun Apr 22, 2018 2:04 pm
Select Slice object, apply Compound Filter.
2. Select CompoundFilter object, go to properties. Switch Filter Type to "specific items".
3. In 'items' property, type a zero.
-> this is your first solid.
4. repeat for however many solids you need to extract, increasing the number you type into 'items' for each step.
Can I move the solids separately?
With the german locale I have a problem with the list, perhaps because ',' is the decimal separator. If I write '0,1' I get an error, I have to use the range instead. The range behaves peculiar as well:
I have an object, which I have sliced in two. Entering the values below yields the following results
items: 0 -> result: first part
items:1 -> result: second part
items: 0:1 -> result: first part
items: 0:2 -> result: both parts