I'm not certain of the nature of your problem. Did you add radius dimensions to different edges, then they all got switched to the same edge after a recompute?
Unfortunately, the author of Drawing Dimensioning stopped its development 2 years ago, and nobody volunteered to pick it up. I doubt that you will get help solving this issue.
On the other hand, when a fillet is the same in multiple places in a part, by common convention you only create one dimension and add "typical" or "typ." to the label, so you don't clutter the drawing view. So the dimension would read "R0.2 (typ.)" (with or without parenthesis)
chrisb wrote: ↑
Mon Sep 03, 2018 8:54 pm
TechDraw is in many ways much more advanced than the afore mentioned combination.
Unfortunately, regarding dimensioning, it is still missing a lot of tools that Drawing Dimensioning offers. Hopefully they will get added in the future. That being said, I see nothing in bridge's screen capture that cannot be done already in TechDraw.