Fillet on edge between touching/intersecting features

Post here for help on using FreeCAD's graphical user interface (GUI).
Forum rules
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help

Also, be nice to others! Read the FreeCAD code of conduct!
chrisb
Posts: 15624
Joined: Tue Mar 17, 2015 9:14 am

Re: Fillet on edge between touching/intersecting features

Postby chrisb » Fri May 17, 2019 10:15 am

The seam issues are well known. Please try int_fillet2.FCStd on the first page of this topic. Turn the seam and report if the fillet succeeds.
openBrain
Posts: 1050
Joined: Fri Nov 09, 2018 5:38 pm

Re: Fillet on edge between touching/intersecting features

Postby openBrain » Fri May 17, 2019 1:23 pm

Sullyvan wrote:
Fri May 17, 2019 9:27 am
I created two components.
:shock: :o With this file I can indeed fillet the 4 inner edges of the part created with revolution. But the original example still doesn't want...
Sullyvan
Posts: 4
Joined: Thu May 16, 2019 2:31 pm

Re: Fillet on edge between touching/intersecting features

Postby Sullyvan » Fri May 17, 2019 2:47 pm

I played around a bit with the file int_fillet2.FCStd.
The way the file is, I can't fillet it where the torus sketch is.
Rotating the sketch by 20degrees allows the fillets to be applied to both cutting edges. See figure 1
But it is easier to place the sketch 10mm outside the rectangle. See figure 2
Attachments
001.PNG
001.PNG (161.8 KiB) Viewed 31 times
002.PNG
002.PNG (185.25 KiB) Viewed 31 times
openBrain
Posts: 1050
Joined: Fri Nov 09, 2018 5:38 pm

Re: Fillet on edge between touching/intersecting features

Postby openBrain » Fri May 17, 2019 2:53 pm

Sullyvan wrote:
Fri May 17, 2019 2:47 pm
I played around a bit with the file int_fillet2.FCStd.
This is int_fillet.FCStd, not int_fillet2. ;)
int_fillet2 is the file attached to this post. :)