Boneshaker wrote: ↑Mon May 20, 2019 3:09 pm Maybe we make a monthly FreeCAD challenge in the showcase forum to build a library of more complex examples.
Windmill project
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Re: Windmill project
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Windmill project
I haven't finished but here's where I left off. The .pdf lists shows the Spreadsheet cells near the corresponding dimension but it is incomplete, it was done before I knew how the finished model was supposed to look, and if I were to do it again I'd only reference a few values from a Spreadsheet (as it is now I think it is more confusing than practical).
OS: Ubuntu 18.04.2 LTS
Word size of OS: 32-bit
Word size of FreeCAD: 32-bit
Version: 0.18.1.
Build type: Release
Python version: 3.6.7
Qt version: 5.9.5
Coin version: 4.0.0a
OCC version: 7.3.0
Locale: English/UnitedStates (en_US)
blue and strike-through = edit for better wording.
Last edited by bejant on Wed May 22, 2019 12:09 pm, edited 1 time in total.
Re: Windmill project
The pdf seems to be damaged. Can anyone else open it?
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Windmill project
Probably attached the wrong file? " The .pdf lists the Spreadsheet cells..."
Re: Windmill project
Here's my take on this little challenge.
I have read that it's really something and not a weird design for a wind turbine only after completing it:)
Made in 1h04min
I have read that it's really something and not a weird design for a wind turbine only after completing it:)
Made in 1h04min
- Attachments
-
- Capture.PNG (61.24 KiB) Viewed 1157 times
-
- windturbine.FCStd
- (203.95 KiB) Downloaded 36 times
Last edited by NCCALCADA on Wed May 22, 2019 12:29 pm, edited 1 time in total.
Re: Windmill project
Sorry, I did save it as a .pdf, and it opens and looks fine for me using Document Viewer (Evince) on Ubuntu 18.04 as shown in the image UR_ posted, but I don;t know how to fix it. I made the annotations and saved it using flpsed (which I hadn't used before) but I don't think I can save it any differently...
Edit: I'll try again later using Okular, which (I think) worked for me here before.
Last edited by bejant on Wed May 22, 2019 12:49 pm, edited 1 time in total.
Re: Windmill project
Yes, but Bonshaker showed us that there was a perching catMade in 1h04min
Re: Windmill project
Maybe this attached pdf is better? I only did the first page and it should look like this:
If it looks ok then I'll add the cell notes to the other pages.
If it looks ok then I'll add the cell notes to the other pages.
Re: Windmill project
Which one is the 12mm hole offset? Also I did not understand what is that 5mm dimension (B18 in your image)?