FREECAD step export

[grijo]

SUP_FREECAD.zip

(659.56 KiB) Downloaded 4 times

Hello,

i use FREECAD to create and edit 3D models of electronic components.
When i open a 3D step model of a component supplier (to move the component origin) and export it from FREECAD the file size increase a lot, sometimes it's up to 5 times larger.

In the attached example the FREECAD step file is three times larger.

My workaround is to open the exported step file in an 3D viewer ( i use Kistler 3DViewStation ) and save it.
Then the file size is smaller.

My question:
How can i export in FREECAD a step file with an adaquate file size. ( comparable to the original file size. )

Joachim

[easyw-fc]

i use FREECAD to create and edit 3D models of electronic components.
When i open a 3D step model of a component supplier (to move the component origin) and export it from FREECAD the file size increase a lot, sometimes it's up to 5 times larger.

please have a look at here:
https://forum.freecadweb.org/viewtopic. ... 08#p320208
https://forum.freecadweb.org/viewtopic. ... 85#p142700

[chrisb]

ping

[grijo]

i use FREECAD to create and edit 3D models of electronic components.
When i open a 3D step model of a component supplier (to move the component origin) and export it from FREECAD the file size increase a lot, sometimes it's up to 5 times larger.

please have a look at here:
https://forum.freecadweb.org/viewtopic. ... 08#p320208
https://forum.freecadweb.org/viewtopic. ... 85#p142700

I disabled parametric curves in step output.
Now the file size is nearly the same the original step file has.

Thx.

[vejmarie]

sorry I was offline for a time. Good to see that you fixed your issue.