Hello
I change Datum plan by Datum Ligne facing on the support
on the same face I do one sketch of halh circle
I rotate it 180°aroud the datum ligne
I do miror for the other side
Sphere creation
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
- papyblaise
- Veteran
- Posts: 8026
- Joined: Thu Jun 13, 2019 4:28 pm
- Location: France
Re: Sphere creation
- Attachments
-
- pion-charnière.FCStd
- (43.87 KiB) Downloaded 12 times
-
- pion-charnière.PNG (35.08 KiB) Viewed 416 times
Re: Sphere creation
I would make the origin visible, double click on the plane and select YZ-plane with attachment mode XY and set z to -55.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Sphere creation
Hello,papyblaise wrote: ↑Fri Aug 09, 2019 12:31 pm Hello
I change Datum plan by Datum Ligne facing on the support
on the same face I do one sketch of halh circle
I rotate it 180°aroud the datum ligne
I do miror for the other side
Thank you.
I've finally done it...
Best regards
- Attachments
-
- rond.png (37.88 KiB) Viewed 368 times