Crash on editing sketch

[friv]

My problem sketch is here. I preferred to make a new one, so as not to deal with the problem in the Freecad code.

That's not a step by step instruction. Tell us where you start the line and where it ends. Show us the state of the Edit controls at the left. Can you simplify the sketch and still get the crash?

Hi Chrisb!

In that example, I will no longer be able to simulate the sequence of steps. If I load that sketch in Freecad (0.18), then the program crashes just by touching the mouse on the desktop. I don't want to waste any more time on this. Perhaps it was worth trying to edit the config files described in Bance message. But I'm sorry to waste time on this.

Sometimes programmers joke: "You don't need to fix mistakes, so as not to make new ones. Errors should be documented"

Regards, Friv.

[Bance]

You haven't shown us an error, nobody else can replicate the behaviour.