Hello, chrisb help me with pipe 2-in-1, but now can not make single body. I add boss and need chamfer to big edge for over hang 3d print with same on bottom 2 pipes. Is it possible?
OS: Linux Mint 19.2 (X-Cinnamon/cinnamon)
Word size of OS: 64-bit
Word size of FreeCAD: 64-bit
Version: 0.19.17499 (Git) AppImage
Build type: Release
Branch: master
Python version: 3.7.3
Qt version: 5.9.7
Coin version: 4.0.0a
OCC version: 7.3.0
How to make joined
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
How to make joined
I am taking EASL at night to make my English better. I use VPN for USA better searching
- papyblaise
- Veteran
- Posts: 7998
- Joined: Thu Jun 13, 2019 4:28 pm
- Location: France
Re: How to make joined
Hello
you can do chanfer 1.99mm , and filet sup at 5mm on the top
you can do chanfer 1.99mm , and filet sup at 5mm on the top
- Attachments
-
- filet.PNG (106.45 KiB) Viewed 836 times
Re: How to make joined
Thank you but I can not chamfer that corner as it will cut through very thin to next inside pocket of 31mm radius. I can not make all longer as height of 2-in-1 is fixed. I can not make big boss section come down any more it stops at 28mm and will not pass over that line where I chamfer now.papyblaise wrote: ↑Mon Sep 02, 2019 4:50 pm you can do chanfer 1.99mm , and filet sup at 5mm on the top
I can not use fillet for 3d print over hang must be chamfer to print to look good.
I am taking EASL at night to make my English better. I use VPN for USA better searching
Re: How to make joined
I am taking EASL at night to make my English better. I use VPN for USA better searching
Re: How to make joined
You can do it with 2 chamfers plus a slightly prolonged collar.
- Attachments
-
- 0902-thick_cb.FCStd
- (261.61 KiB) Downloaded 33 times
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
- papyblaise
- Veteran
- Posts: 7998
- Joined: Thu Jun 13, 2019 4:28 pm
- Location: France
Re: How to make joined
5mm isn't chanfer , but filet
on mine file
on mine file
Last edited by papyblaise on Tue Sep 03, 2019 7:27 am, edited 1 time in total.
Re: How to make joined
Which model are you talking about? In my model are no fillets and two chamfers, one 3.8mm and another with 3.9.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.