kisolre wrote: ↑
Mon Oct 07, 2019 12:06 pm
Here is what Slic3r gives with average settings:
123 MB G-code file !!!
On my slow printer it will take 17.5 h and with those 0.5mm holes I am pretty sure it will fail miserably. Those are a lot of small extrusions and small travel moves, probably a lot of retractions also.
I don't have the benchmark on typical size for G-code... what's the standard/average size?
That's one more reason to think that there is an issue in my design.... :/
Regarding the printer, the fablab has an WITBOX2 which has a resolution of up to 20 microns.
I suppose it should be enough in my case?