pl7i92LCNC wrote: ↑
Wed Oct 16, 2019 4:50 pm
unfold workes fine wit the appimage
the file is unfolded with the Bottom outer face selected
and by pressing the unfold key in the topbar
Bend lines are visible
From what I can see in the image you posted, not all the bend lines seem to be visible. This is beyond frustrating, as I have tried to even rebuild this several times. It just doesn't work for me.
My latest try was to not use the pad from the part design workbench on the initial sketch on the bottom of the box, and instead use the sheet metal workbench to create the bottom from the sketch. When I did the bends, then the bends where all dependent on each other, which seemed like the better approach. It still didn't work.
The reason this is important, is because I need to create a 2D drawing, using the TechDraw workbench, and show the measurements for all the bend lines.
I have attached my revised model, doing it all, including creating the bottom, through the sheet metal workbench.