Trying to figure out way to taper layers between each other?
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
-
- Posts: 12
- Joined: Fri May 01, 2020 7:50 pm
Trying to figure out way to taper layers between each other?
Not sure if thats best way to describe it but on this example it has the thin rim going around the entire circumference of the part, if I wanted it to be the pocket height at that far corner bolt hole around .400" thick (thats just currently surround by raised lip for no reason) and ramp up to the raised pad parts of the item @1.1" thick for example how would you do something like that?
- Attachments
-
- Screenshot (105).png (252.11 KiB) Viewed 203 times
Re: Trying to figure out way to taper layers between each other?
You have to use Expressions to calculate the radius. Please note that the fillet cannot touch the hole, you need a tiny gap of e.g. 1/1000mm.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Trying to figure out way to taper layers between each other?
Include a file.