Basically I want to make flower bud type design around circular surface
Stuck at cut
Kindly help
Can't cut
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
-
Msilrajesh
- Posts: 2
- Joined: Fri Nov 27, 2020 9:59 pm
Can't cut
Iam not able to cut 2 shapes
Basically I want to make flower bud type design around circular surface
Stuck at cut
Kindly help
Basically I want to make flower bud type design around circular surface
Stuck at cut
Kindly help
- Attachments
-
- Bud bottle.FCStd
- (33.3 KiB) Downloaded 12 times
-
Msilrajesh
- Posts: 2
- Joined: Fri Nov 27, 2020 9:59 pm
Re: Can't cut
Did any one see..please help!!
Re: Can't cut
Hello and welcome to the forum!
From your file it is not very clear what you want to Cut from what ?!? You also used Part Loft instead of PartDesigh Additive Loft which creates Links Out Of Scope. Could you show the next step that you tried and an example of what the final result should look like?
From your file it is not very clear what you want to Cut from what ?!? You also used Part Loft instead of PartDesigh Additive Loft which creates Links Out Of Scope. Could you show the next step that you tried and an example of what the final result should look like?
-
papyblaise
- Veteran
- Posts: 8000
- Joined: Thu Jun 13, 2019 4:28 pm
- Location: France
Re: Can't cut
I would like but I don't understand what you want
you made a Pad in Partdesign, and a loft in Part, it's not compatible
and if you want to turn the Loft, it was better to make the circles in the plane where you want it
you made a Pad in Partdesign, and a loft in Part, it's not compatible
and if you want to turn the Loft, it was better to make the circles in the plane where you want it
Re: Can't cut
Another problem is that your sketch is missing two coincident constraints at the places I marked in a green color
- Attachments
-
- Constraints.png (237.6 KiB) Viewed 257 times
Re: Can't cut
Seeing this sketch you should also
- not use 0mm or 0° dimensions, use geometric constraints such as point-on-line instead
- prefer geometric constraints over dimensions, in your case use symmetry instead of repeating 3mm.
- not use 0mm or 0° dimensions, use geometric constraints such as point-on-line instead
- prefer geometric constraints over dimensions, in your case use symmetry instead of repeating 3mm.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Can't cut
... what the heck is a BudBottle?
- BudBottle_2.JPG (31.53 KiB) Viewed 212 times
- Attachments
-
- Bud bottle_3.FCStd
- FC.18.4
- (148.5 KiB) Downloaded 4 times
-
- Bud bottle_2.FCStd
- (29.46 KiB) Downloaded 4 times