a question comes to me: why didn't you put an undercut in the direction of the 20mm?
that does not pose any more problem and that makes a pretty kepi of gend'arme of France
Can't create fillet between two bodies.
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
- papyblaise
- Veteran
- Posts: 8027
- Joined: Thu Jun 13, 2019 4:28 pm
- Location: France
Re: Can't create fillet between two bodies.
- Attachments
-
- resistor box2.PNG (25.99 KiB) Viewed 645 times
-
- Resistor Box 2.FCStd
- (71.68 KiB) Downloaded 24 times
Re: Can't create fillet between two bodies.
if you are dead set on getting it done, you can probably get there by resorting to break up the geometry, manipulate and rebuild...
part wb fillet will make one degenerated fillet (well, not on your model directly, but on one that is build slightly different)
that one can be broken up and the degenerated face can be removed,
since one side is ok, that one is mirrored, then the whole thing is rebuilt to a solid.
not a very efficient way, but it is one way to get you there.
you should be able to trace back the steps from this model.
part wb fillet will make one degenerated fillet (well, not on your model directly, but on one that is build slightly different)
that one can be broken up and the degenerated face can be removed,
since one side is ok, that one is mirrored, then the whole thing is rebuilt to a solid.
not a very efficient way, but it is one way to get you there.
you should be able to trace back the steps from this model.
- Attachments
-
- rb.FCStd
- (152.62 KiB) Downloaded 25 times
Re: Can't create fillet between two bodies.
Greetings to the Community!
Another workflow proposal to "force" FC to produce a fillet with a 2.5 mm radius. respecting the original tapering and overall dimensions.
Another workflow proposal to "force" FC to produce a fillet with a 2.5 mm radius. respecting the original tapering and overall dimensions.
- Attachments
-
- Resistor Box Test.FCStd
- (249.44 KiB) Downloaded 31 times
-
- Resistor_Box_R-2_5.png (170.18 KiB) Viewed 580 times
Re: Can't create fillet between two bodies.
Instead of applying a final Part refine, it is better set the refine property in the last Pocket.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Can't create fillet between two bodies.
Thanks Chrisb, I didn't pay due attention!
Operating on the last pocket you earn 27 Kb (which is the weight of the finished copy) which is about 11% less (a big difference! )
Re: Can't create fillet between two bodies.
What is even more important to me is a simpler and hopefully clearer model.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.