Erro no polarPattern
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
-
- Posts: 22
- Joined: Tue Jun 15, 2021 8:39 am
- Location: Sweden
- Contact:
Erro no polarPattern
Could someone help me understand how to configure the PolarPattern axis with a macro or directly by its configuration because when I create it it is ok but if I edit it without opening it I say in the configuration it says it has no reference axis, attached prints of what I'm saying.
- Attachments
-
- test_1.png (41.35 KiB) Viewed 445 times
-
- test_1.0.png (57.74 KiB) Viewed 445 times
Re: Erro no polarPattern
Maybe look at the bigger problem first: You are working in the PartDesign WB but judging from the images there is no Body. This should not happen.
- papyblaise
- Veteran
- Posts: 8002
- Joined: Thu Jun 13, 2019 4:28 pm
- Location: France
Re: Erro no polarPattern
as Roy says, there is indeed a fatal error for using PartDesign, but it might be good for bad because you are actually working in PartWB so if you continue in Part, the miror may be use in all major axes, but also by setting an offset of the origin, and also following an arbitrary line drawn before
In Partdesign, you define a DatumLine and use it as a specific axis
you also risk getting yelled at because you create 2 separate bodies which is forbidden, which is not the risk in Part
In Partdesign, you define a DatumLine and use it as a specific axis
you also risk getting yelled at because you create 2 separate bodies which is forbidden, which is not the risk in Part
Last edited by papyblaise on Thu Jun 17, 2021 11:20 am, edited 1 time in total.
Re: Erro no polarPattern
Please post your FreeCAD version data in the manner explained in the forum rules link above this forum.