Bug: Fillet breaking surface

[Cekuhnen]

FreeCAD 0.12
macOS Big Sur


adding a fillet to selected face

Screen Shot 2021-07-16 at 12.10.54 AM.png (51.6 KiB) Viewed 872 times

consumes the bottom

Screen Shot 2021-07-16 at 12.11.08 AM.png (95.65 KiB) Viewed 872 times

two edges is also quite funny

Screen Shot 2021-07-16 at 12.12.52 AM.png (65.77 KiB) Viewed 872 times

File is attached

Same issue happens also with a solid loft spout

[Cekuhnen]

BTW in part mode this works - not sure if this helps

Screen Shot 2021-07-16 at 1.12.33 AM.png (36.03 KiB) Viewed 850 times

[Forthman]

I think you just discovered a new bug!



no I'm kidding (but it's pretty nice, isn't it?)

edit : the cylinder seal must not be aligned with the spout

[chrisb]

To add to Forthman: If you take the same Body that failed and fillet it in Part workbench, it fails as well. Fillets tend to break when four edges meeting in a point are involved.

[Shalmeneser]

If the fillet is not on the seam of the cylinder...
Or you can draw the fillet in the sketch.

[papyblaise]

yes but there you made a teapot for right-handed people only, left-handed people will get their pants wet, choking,
but it is the right solution to avoid the shape in 4 edges which blocks the good process

[Cekuhnen]

edit : the cylinder seal must not be aligned with the spout

I assumed incorrectly that because the spout is a different body that the filet applied to just the spout edge will result in the desired surface detail.

[papyblaise]

FreeCAD 0.12
macOS Big Sur

what do I see on which archaeological site you found that
I did not know that the pyramids of Egipte were drawn with Fc

[Shalmeneser]

Body double ?
Why 2 bodies ?

[Cekuhnen]

Sushi tasted good for lunch.