is Part design WB Thickeness very sensitive?
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Re: is Part design WB Thickeness very sensitive?
Yeah I did that too but when I pad extruded it up to lid it extruded the wall through lid and in addition cut the center out like it was pad and pocket together
I used the face align
I used the face align
MacOS Big Sur / Win 10
Designer | Faculty
Wayne State University
Interior - Industrial Design
Designer | Faculty
Wayne State University
Interior - Industrial Design
Re: is Part design WB Thickeness very sensitive?
When I discuss Pad and Extrude, I always make sure to make it clear whether I am, indeed, talking about Pad or Extrude.
In FreeCAD they are similar but different.
Yes, I know full well, in other software the term "extrude" is used and in the CAD world at large it is a term used widely.
But, the difference between Pad and Extrude is a point of confusion for, especially new comers, and in conversations with old timers when the operation names are used without context.
I've helped and tutored a fair number of FreeCAD users and found it helps to make it abundantly clear.
Star Trek II: The Wrath of Khan: Spock: "...His pattern indicates two-dimensional thinking."
Re: is Part design WB Thickeness very sensitive?
Ok should have said used the pad tool or padded it to the lid’s under surface
MacOS Big Sur / Win 10
Designer | Faculty
Wayne State University
Interior - Industrial Design
Designer | Faculty
Wayne State University
Interior - Industrial Design
Re: is Part design WB Thickeness very sensitive?
oh man lack of offset and selecting sketch profiles for pocket or pad makes this frustrating detail to model those slots
MacOS Big Sur / Win 10
Designer | Faculty
Wayne State University
Interior - Industrial Design
Designer | Faculty
Wayne State University
Interior - Industrial Design
Re: is Part design WB Thickeness very sensitive?
Here is a thickness that works. Made a pad first and carved it up.
- Attachments
-
- Thick_build1.FCStd
- (69.62 KiB) Downloaded 17 times
-
- thick1.JPG (32.95 KiB) Viewed 508 times
Re: is Part design WB Thickeness very sensitive?
Ah interesting
Pad up first then pocket around
Pad up first then pocket around
MacOS Big Sur / Win 10
Designer | Faculty
Wayne State University
Interior - Industrial Design
Designer | Faculty
Wayne State University
Interior - Industrial Design
Re: is Part design WB Thickeness very sensitive?
This one does some complex thickening on the inside, around the pocket.
- Attachments
-
- Thick_build2.FCStd
- (94.37 KiB) Downloaded 15 times
-
- thick2.JPG (36.8 KiB) Viewed 485 times
Re: is Part design WB Thickeness very sensitive?
Constrained Array in Sketcher, pretty easy, like 2 minutes. Unless your trying to follow the radius, that will take a little effort.Cekuhnen » wrote
oh man lack of offset and selecting sketch profiles for pocket or pad makes this frustrating detail to model those slots
Re: is Part design WB Thickeness very sensitive?
What first came to my mind is make the slots go out of the part at the bottom and use pad and pocket to close the model again.
Regards / Viele Grüße
Max
Max
Re: is Part design WB Thickeness very sensitive?
Pocket one side.
- Attachments
-
- Capture2.JPG (66.08 KiB) Viewed 458 times