When hole depth reaches the other end of the object, the full thin disappears.
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
When hole depth reaches the other end of the object, the full thin disappears.
Hey, I use version 0.20.
When I set the depth parameter of Hole002 to 30mm (so it would make a hole through all the way), the part disappears.
1, why?
2, why was this not a problem with my other holes?
Thanks!!
When I set the depth parameter of Hole002 to 30mm (so it would make a hole through all the way), the part disappears.
1, why?
2, why was this not a problem with my other holes?
Thanks!!
- Attachments
-
- CG tartó.FCStd
- (42.29 KiB) Downloaded 40 times
Last edited by Enomeee on Fri Oct 08, 2021 12:54 pm, edited 1 time in total.
Re: When hole depth reaches the other end of the object, the full thin disappears.
When I open your file it looks weird, why?
Re: When hole depth reaches the other end of the object, the full thin disappears.
Not sure what weird means to you
But maybe it is due to software version difference.
But maybe it is due to software version difference.
Re: When hole depth reaches the other end of the object, the full thin disappears.
Sketch is invalid, no T-joins are allowed.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: When hole depth reaches the other end of the object, the full thin disappears.
Whats wrong with this picture?
Re: When hole depth reaches the other end of the object, the full thin disappears.
I think it's LS3....
- Shalmeneser
- Veteran
- Posts: 9560
- Joined: Wed Dec 23, 2020 12:04 am
- Location: Fr
Re: When hole depth reaches the other end of the object, the full thin disappears.
Which FC version ?
Sketch(000) :
* T jonctions are forbidden
* 2 lines at the same place
Sketch m4 :
* support=Face : bad practice (TNP)
* tool PartDesign_Hole needs only circle (or arc), not rectangle (use Sketcher_ToggleConstruction)
Sketch 10es lyuk :
* dimension=0 : bad practice => use Sketcher_ConstrainPointOnObject
Sketch004 :
* twice 4mm : bad practice => use Sketcher_ConstrainEqual
* support=Face : bad practice (TNP)
At the end : Refine=true
Sketch(000) :
* T jonctions are forbidden
* 2 lines at the same place
Sketch m4 :
* support=Face : bad practice (TNP)
* tool PartDesign_Hole needs only circle (or arc), not rectangle (use Sketcher_ToggleConstruction)
Sketch 10es lyuk :
* dimension=0 : bad practice => use Sketcher_ConstrainPointOnObject
Sketch004 :
* twice 4mm : bad practice => use Sketcher_ConstrainEqual
* support=Face : bad practice (TNP)
At the end : Refine=true
- Attachments
-
- CG tartó_SHALM.FCStd
- (49.47 KiB) Downloaded 27 times