Constraints In A2Plus

Post here for help on using FreeCAD's graphical user interface (GUI).
Forum rules
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help

Also, be nice to others! Read the FreeCAD code of conduct!
Post Reply
keltel
Posts: 57
Joined: Fri Oct 15, 2021 11:52 pm

Constraints In A2Plus

Post by keltel »

Hello again.

I have an A2Plus assembly containing 2 parts. I currently have them constrained on 2 planes so that they are butted together at the end and along the lengths. Please see the picture. I would like to however make a constraint that centres the narrow part over a line on the wider part, such that the red lines meet in the picture. The narrower part does have some holes which could possibly be used to glean the centre of the part for alignment purposes if that helps. Is there a way to make this constraint?

TIA. Kel.

Image
Attachments
Assembly.FCStd
(13.23 KiB) Downloaded 29 times
Post Reply