Hello again.
I have an A2Plus assembly containing 2 parts. I currently have them constrained on 2 planes so that they are butted together at the end and along the lengths. Please see the picture. I would like to however make a constraint that centres the narrow part over a line on the wider part, such that the red lines meet in the picture. The narrower part does have some holes which could possibly be used to glean the centre of the part for alignment purposes if that helps. Is there a way to make this constraint?
TIA. Kel.
Constraints In A2Plus
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Constraints In A2Plus
- Attachments
-
- Assembly.FCStd
- (13.23 KiB) Downloaded 29 times