Chamfer full height

[omen]

E.g. my part is 27mm height and I want to chamfer it flush, however I can't set chamfer size to 27mm, only 26mm and it leaves 1mm uncut. How can I chamfer full height?

Untitled.png (38.06 KiB) Viewed 837 times

[chrisb]

The geometric kernel can fail if a chamfer consumes all of an adjacent face or edge. Try current 0.20, it chamfered a testfile here quite well.

[domad]

.....

Hi
.... and/or set chamfer to 26.99 mm

[TheMarkster]

Try using the Draft tool instead of a chamfer.

[freedman]

That should probably be done in a sketch as a angled line. Draft is what I think your after but they are not all that stable.

[omen]

Chose 26.99mm option. Thanks all!