Re: Compound Curve for Sweep Additive Pipe

Post here for help on using FreeCAD's graphical user interface (GUI).
Forum rules
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help

Also, be nice to others! Read the FreeCAD code of conduct!
Post Reply
3dHacker
Posts: 35
Joined: Sun Aug 08, 2021 9:15 pm

Re: Compound Curve for Sweep Additive Pipe

Post by 3dHacker »

TheMarkster
Thanks for the pointers. It took a couple of tries, but I think that I got it.

As an aside, I had posted a reply last night. I attached an image and clicked Preview. Made a very slight correction and clicked
Submit. Did a refresh and saw that my post was there. For some reason, I did a second refresh and my post, the whole thread
and the only two other threads that I had posted to were all gone! Yikes!

Have no idea who to mention that to.

Anyway, again thank you. I see that I have lots to learn, FreeCAD is a rather large and impressive bit of software.

GA
Attachments
747 (back).png
747 (back).png (31.19 KiB) Viewed 1170 times
742.png
742.png (31.57 KiB) Viewed 1170 times
Post Reply