I have the element circled in red on the XY plane and I tired to mirror it to produce three other copies each at a corner of a box. The top-left mirrored element's orientation is good (vertical sketch axis) but I can't seem to figure out how to get the bottom two to point "upwards" with the same orientation as the original. How can I do this? Currently the bottom two are on the horizontal sketch axis.
[Solved] Part Design Mirror
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
-
- Posts: 2
- Joined: Mon Oct 25, 2021 12:40 am
[Solved] Part Design Mirror
Last edited by DanielSchmaniel on Tue Oct 26, 2021 12:13 am, edited 1 time in total.
Re: Part Design Mirror
Hi and welcome to the forum!
You cannot do this with a mirror, because what you want is no mirror. Use a linear pattern instead. Expressions tells you how to make this even parametric.
You cannot do this with a mirror, because what you want is no mirror. Use a linear pattern instead. Expressions tells you how to make this even parametric.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
-
- Posts: 2
- Joined: Mon Oct 25, 2021 12:40 am
Re: Part Design Mirror
Spot on. Thank you. I played with the liner pattern before this but I guess I got frustrated before seeing that it could work. Again thanks for your help.