Injection Molding Analysis for Plastics

Post here for help on using FreeCAD's graphical user interface (GUI).
Forum rules
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help

Also, be nice to others! Read the FreeCAD code of conduct!
Post Reply
frcaduser
Posts: 321
Joined: Wed Apr 07, 2021 11:22 pm

Injection Molding Analysis for Plastics

Post by frcaduser »

Hi,

is there a FC tool workbench that is used for analyzing potential shrink/sink marks on a designed CAD file?
I have attached a generic screenshot to highlight what it is that I am interested in.

I looked on the FC forum and referenced the following thread:

Plastic injection moulding
by mindflow » Mon Dec 17, 2018 11:01 am

However, there was not much information on a specific tool extension/workbench.

Any help would be greatly appreciated.

Thank you all in advance to all that can help with this issue.
Attachments
plasticPartShrink_Sink_Mark_Analysis.png
plasticPartShrink_Sink_Mark_Analysis.png (67.06 KiB) Viewed 2027 times
Post Reply