Hi,
is there a FC tool workbench that is used for analyzing potential shrink/sink marks on a designed CAD file?
I have attached a generic screenshot to highlight what it is that I am interested in.
I looked on the FC forum and referenced the following thread:
Plastic injection moulding
by mindflow » Mon Dec 17, 2018 11:01 am
However, there was not much information on a specific tool extension/workbench.
Any help would be greatly appreciated.
Thank you all in advance to all that can help with this issue.
Injection Molding Analysis for Plastics
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Injection Molding Analysis for Plastics
- Attachments
-
- plasticPartShrink_Sink_Mark_Analysis.png (67.06 KiB) Viewed 2061 times