Hello to all,
I am new on FreeCad and I would like to know from the experimented users of FreeCad if it is possible to design lead moulds using FreeCad.
I will attach below some pictures with what I want to do and please advice me if it is possible or not.
Thank you for any response,
Make carp fishing lead moulds with FreeCad
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
-
- Posts: 2
- Joined: Wed Dec 01, 2021 3:19 pm
Re: Make carp fishing lead moulds with FreeCad
Hi and welcome to the forum!
Looks on first sight like a revolve, followed by a pocket to flatten the bottom and some more angled sketches creating the air channels. The conic inlet can be a subtractive cone or a groove.
Finally the thing is multipatterned by mirror and linear pattern.
Looks on first sight like a revolve, followed by a pocket to flatten the bottom and some more angled sketches creating the air channels. The conic inlet can be a subtractive cone or a groove.
Finally the thing is multipatterned by mirror and linear pattern.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Make carp fishing lead moulds with FreeCad
air channels. The conic inlet In casting lingo that would be vents and sprue.chrisb wrote: ↑Wed Dec 01, 2021 4:49 pm Hi and welcome to the forum!
Looks on first sight like a revolve, followed by a pocket to flatten the bottom and some more angled sketches creating the air channels. The conic inlet can be a subtractive cone or a groove.
Finally the thing is multipatterned by mirror and linear pattern.
Star Trek II: The Wrath of Khan: Spock: "...His pattern indicates two-dimensional thinking."
Re: Make carp fishing lead moulds with FreeCad
Hello, greetings to the Community!
From the images I think it is possible to make them in FC
From the images I think it is possible to make them in FC
Re: Make carp fishing lead moulds with FreeCad
I may remember "vent" for some time, but I'm afraid that I will soon have forgotten "sprue" .
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
- papyblaise
- Veteran
- Posts: 8002
- Joined: Thu Jun 13, 2019 4:28 pm
- Location: France
Re: Make carp fishing lead moulds with FreeCad
voilà
- Attachments
-
- plomb.FCStd
- (145.42 KiB) Downloaded 27 times
-
- plomb.PNG (12.59 KiB) Viewed 835 times
-
- Posts: 2
- Joined: Wed Dec 01, 2021 3:19 pm
Re: Make carp fishing lead moulds with FreeCad
Monsieur, vous etez le meilleure! Merci beaucoup!
Sir, you are the best! Thank you very much!