Extra Line in Drawing

[Vagulus]

There is an extra line in this Drawing marked 'A'.
How do I avoid it?

FCStd is here https://1drv.ms/u/s!ArMxdUYEh9fKwBri9KC ... W?e=PkHxmC.

Thanks

[Shalmeneser]

There is an extra line in this Drawing marked 'A'.

A ? Where ? What ?

[Shalmeneser]

[Vagulus]

Thanks for trying.

[Shalmeneser]

A : (in reference to other post ) : seam line = false ?

[Vagulus]

I don't know what you are trying to say.
I toggled off the seam line in your 3D model of a Cone

220131 Cone Sans Seam 3D Model.png (68.05 KiB) Viewed 783 times

and then created a drawing from the unseamly cone

220131 Cone Sans Seam Drawn.png (29.29 KiB) Viewed 783 times

and the line is still there.

[chrisb]

You probably changed the draw style in 3D view to shaded, but that doesn't switch the seamline off. The seam of an object is always there even if you don't see it; it is the base for the object as can be seen in wireframe mode.
You have to set in TechDraw SeamVisible=False.

[Vagulus]

You probably changed the draw style in 3D view to shaded, but that doesn't switch the seamline off
...
You have to set in TechDraw SeamVisible=False.

That's what I did.
This was the light at the end of the tunnel:
https://forum.freecadweb.org/viewtopic. ... 69#p450127


That's a long road to a simple answer.
Thanks folks