There is an extra line in this Drawing marked 'A'.
How do I avoid it?
FCStd is here https://1drv.ms/u/s!ArMxdUYEh9fKwBri9KC ... W?e=PkHxmC.
Thanks
Extra Line in Drawing
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Extra Line in Drawing
- Attachments
-
- 220120 Driver Sprocket Dwg.pdf
- (392.29 KiB) Downloaded 20 times
"It is much harder to simplify than to complicate."
Joseph Kimble
Joseph Kimble
- Shalmeneser
- Veteran
- Posts: 9582
- Joined: Wed Dec 23, 2020 12:04 am
- Location: Fr
Re: Extra Line in Drawing
A ? Where ? What ?
- Shalmeneser
- Veteran
- Posts: 9582
- Joined: Wed Dec 23, 2020 12:04 am
- Location: Fr
Re: Extra Line in Drawing
- Attachments
-
- Capture du 2022-01-20 23-24-25.png (61.28 KiB) Viewed 969 times
-
- 220120 Driver Sprocket_SHALM.FCStd
- (947.21 KiB) Downloaded 15 times
Re: Extra Line in Drawing
Thanks for trying.
- Attachments
-
- 220121 Shalmaneser's Drawing.pdf
- (355.69 KiB) Downloaded 19 times
"It is much harder to simplify than to complicate."
Joseph Kimble
Joseph Kimble
- Shalmeneser
- Veteran
- Posts: 9582
- Joined: Wed Dec 23, 2020 12:04 am
- Location: Fr
Re: Extra Line in Drawing
A : (in reference to other post ) : seam line = false ?
- Attachments
-
- Capture du 2022-01-21 00-13-41.png (11.1 KiB) Viewed 930 times
-
- SeamLine.FCStd
- (20.68 KiB) Downloaded 15 times
Re: Extra Line in Drawing
I don't know what you are trying to say.
I toggled off the seam line in your 3D model of a Cone and then created a drawing from the unseamly cone and the line is still there.
I toggled off the seam line in your 3D model of a Cone and then created a drawing from the unseamly cone and the line is still there.
"It is much harder to simplify than to complicate."
Joseph Kimble
Joseph Kimble
Re: Extra Line in Drawing
You probably changed the draw style in 3D view to shaded, but that doesn't switch the seamline off. The seam of an object is always there even if you don't see it; it is the base for the object as can be seen in wireframe mode.
You have to set in TechDraw SeamVisible=False.
You have to set in TechDraw SeamVisible=False.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Extra Line in Drawing
That's what I did.
This was the light at the end of the tunnel:
https://forum.freecadweb.org/viewtopic. ... 69#p450127
That's a long road to a simple answer.
Thanks folks
"It is much harder to simplify than to complicate."
Joseph Kimble
Joseph Kimble