Difficult AdditiveLoft

Post here for help on using FreeCAD's graphical user interface (GUI).
Forum rules
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help

Also, be nice to others! Read the FreeCAD code of conduct!
Katana
Posts: 22
Joined: Sat May 14, 2022 6:07 pm

Re: Difficult AdditiveLoft

Post by Katana »

Thank you Shalmeneser!
I have now printed out the part with the, for me difficult funnel. With your help I have learned a lot, that I could not find among all YouTubers I have searched. OK, I have to print it once more, as I did mess up by mixing the radius and diameter measures, so it did not fit in its place.

But I am pretty sure my 3D printer will be happy to work for another 6 Hours :D

Thanks
Attachments
espresso part.jpg
espresso part.jpg (84.07 KiB) Viewed 333 times
User avatar
Shalmeneser
Veteran
Posts: 9475
Joined: Wed Dec 23, 2020 12:04 am
Location: Fr

Re: Difficult AdditiveLoft

Post by Shalmeneser »

Katana wrote: Tue May 17, 2022 9:45 am OK, I have to print it once more, as I did mess up by mixing the radius and diameter measures, so it did not fit in its place.
But I am pretty sure my 3D printer will be happy to work for another 6 Hours :D
When you have fitting conditions, you should 3d Print just the fitting zone to check for compliance. Less time/material needed.

File ?
Katana
Posts: 22
Joined: Sat May 14, 2022 6:07 pm

Re: Difficult AdditiveLoft

Post by Katana »

OK :!:
Post Reply