I will link a video to it
Challenges?
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
- thomas-neemann
- Veteran
- Posts: 11915
- Joined: Wed Jan 22, 2020 6:03 pm
- Location: Osnabrück DE 🇩🇪
- Contact:
Re: Challenge?
Re: Challenge?
Why not. I didn't save the file and had to recreate it, it may look a bit different now.thomas-neemann wrote: ↑Fri Jun 24, 2022 7:29 am I think this is a good time. can you upload the file to learn from it?
- Attachments
-
- Challenge-20220624.png (211.21 KiB) Viewed 4250 times
-
- Challenge-20220624.FCStd
- (91.69 KiB) Downloaded 40 times
- papyblaise
- Veteran
- Posts: 8000
- Joined: Thu Jun 13, 2019 4:28 pm
- Location: France
Re: Challenge?
I went to recharge my batteries by eating a handful of cherries in my garden, and, in a few minutes and a single Wb
- Attachments
-
- 999-1.FCStd
- (86.75 KiB) Downloaded 49 times
Re: Challenge?
About 10-15mins...
Strangely the first pocket fails if the polar pattern is applied to last three ops YMMV.
Strangely the first pocket fails if the polar pattern is applied to last three ops YMMV.
- Attachments
-
- Snip macro screenshot-41c60f.png (16.79 KiB) Viewed 4209 times
-
- challengeBance.FCStd
- (99.71 KiB) Downloaded 56 times
- thomas-neemann
- Veteran
- Posts: 11915
- Joined: Wed Jan 22, 2020 6:03 pm
- Location: Osnabrück DE 🇩🇪
- Contact:
- thomas-neemann
- Veteran
- Posts: 11915
- Joined: Wed Jan 22, 2020 6:03 pm
- Location: Osnabrück DE 🇩🇪
- Contact:
Re: Challenge?
wonderful, you're the fastest so far.
here is mine at 3:20
https://www.youtube.com/watch?v=tVnGnqkYSaw
Last edited by thomas-neemann on Sat Jun 25, 2022 7:27 am, edited 1 time in total.
Re: Challenge?
How many videos does it need ?thomas-neemann wrote: ↑Sat Jun 25, 2022 4:59 am wonderful, you're the fastest so far. can you link a video of it?
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Challenge?
First time I see that Draft Upgrade can make Solids. This feature is also not mentioned in the Freecad documentation page https://wiki.freecadweb.org/Draft_Upgrade
- thomas-neemann
- Veteran
- Posts: 11915
- Joined: Wed Jan 22, 2020 6:03 pm
- Location: Osnabrück DE 🇩🇪
- Contact:
Re: Challenge?
if there was no video editing software to cut out pauses for thought, I suspect about 10