Question on Alignment.
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Re: Question on Alignment.
Ok, of course it must be the body selection, otherwise one would be operating on a feature, which as found out wouldn't work.
Re: Question on Alignment.
Yes, other solids, so part objects and probably Arch/Bim.
The wiki just states objects, I didn't try with sketches/wires etc.
The wiki just states objects, I didn't try with sketches/wires etc.
Re: Question on Alignment.
OK thanks @Bance
Re: Question on Alignment.
There are two reasons (at least) why that doesn't work: The Pad has no Placement and no AttachmentOffset and thus cannot be aligned, and it would lead to a link going out of scope.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Question on Alignment.
OK Thanks @Chrisb
Re: Question on Alignment.
Try Std_SelBoundingBox with an added LCS at each body and select the Bodies. This will show you where they really are
Last edited by mfro on Tue Jul 05, 2022 5:06 pm, edited 1 time in total.
Cheers,
Markus
Markus
Re: Question on Alignment.
Thanks @mfro I will try.
Re: Question on Alignment.
Not much. But it helps to know where and why Bodies are located as they are.
Cheers,
Markus
Markus