Hello,
is it possible to set a radiant constraint instead of an angle constraint in the sketcher? The same for the polar pattern.
In my part it would be easier to set a distance at the arc in mm instead of an angle.
Radiant constraint
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Radiant constraint
- Attachments
-
- 1.png (86.46 KiB) Viewed 476 times
Re: Radiant constraint
I don't know what a radiant constraint is?
But if it refers to using Radians rather than degrees, simply force the unit by entering E.G 1 rad instead of 57.29 deg
But if it refers to using Radians rather than degrees, simply force the unit by entering E.G 1 rad instead of 57.29 deg
Re: Radiant constraint
Thanks.
Re: Radiant constraint
Maybe this radian constraint could look like this:
- Attachments
-
- 2.png (27.16 KiB) Viewed 432 times
Re: Radiant constraint
You can do this by using expressions.
In this case the angle subtended by an arc of 30mm = 30/280 rad or more generally s/r where s = arc length, r = radius of arc.
In this case the angle subtended by an arc of 30mm = 30/280 rad or more generally s/r where s = arc length, r = radius of arc.
Re: Radiant constraint
- Attachments
-
- Bildschirmfoto 2022-09-26 um 23.55.18.png (62.52 KiB) Viewed 395 times
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.