Hello,
I tried to revolve Sketch081 with DatumLine002 and 360°.
The same with Sketch083 and DatumLine002.
I always get a calculation error.
Revolution on DatumLine
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Revolution on DatumLine
- Attachments
-
- pipe.FCStd
- (755.92 KiB) Downloaded 16 times
-
- 1.png (58.63 KiB) Viewed 306 times
Re: Revolution on DatumLine
It's a co-planar issue, you may search the forum for a deeper explanation.
Basically it is a rounding error in computation, you can workaround by making the revolution before the pocket, and adjusting such that the pocket has a different diameter than the ID of the revolve.
Basically it is a rounding error in computation, you can workaround by making the revolution before the pocket, and adjusting such that the pocket has a different diameter than the ID of the revolve.
- Attachments
-
- revolve.png (69.07 KiB) Viewed 293 times
Re: Revolution on DatumLine
Seems to be a coplanar issue. It works with a slightly modified sketch moving the revolve up the tree:
Edit: crosspost with Bance.
I removed the last pattern to reduce the filesizeEdit: crosspost with Bance.
- Attachments
-
- pipe_cb.FCStd
- (900.89 KiB) Downloaded 14 times
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.