Thanks for the replies.
I really only need a freeCAD file (which I could possibly modify later) and a DXF file.
The DXF file is for a machinist to create the faceplates with a CNC mill. He uses "GibbsCAM 2016" which imports the DXF file.
The plates is 78 x 35 mm.
The "1, 2, 3, 4" can be any reasonable font. Arial, etc.
I have an SVG and DXF file for the "DVMon" logo. I've tested and both can be imported into FreeCAD. But then I get 360 degrees of freedom and don't know how to scale it to fit on the part.
I have a DXF file with a "Power Symbol" in it.
The lettering (logo, 1234, and power symbol are etched as, umm, a pocket (?)
The left & right screw holes are countersunk like the picture below (screen shot from Front Panel Designer) .