TechDraw drawing rendering as only gray window

Discussions about the development of the TechDraw workbench
User avatar
wandererfan
Posts: 3161
Joined: Tue Nov 06, 2012 5:42 pm

Re: TechDraw drawing rendering as only gray window

Postby wandererfan » Mon Dec 02, 2019 7:39 pm

mcdanlj wrote:
Sun Dec 01, 2019 7:11 pm
[*]The Vertical-A section is upside down
It looks right side up to me, but I always get turned around with sections.

Here are the 3D and 2D starting points with the section plane shown in both
QCTP_Plane.png
QCTP_Plane.png (60.79 KiB) Viewed 61 times
The is the original shape after the section cut
QCTP_Cut.png
QCTP_Cut.png (55.75 KiB) Viewed 61 times

And here are the results rotated so we are looking down at the cut surface
QCTP_Section.png
QCTP_Section.png (69.76 KiB) Viewed 61 times
If it isn't right, please show what it should look like. Thanks.
mcdanlj
Posts: 5
Joined: Sun Dec 01, 2019 12:10 am

Re: TechDraw drawing rendering as only gray window

Postby mcdanlj » Mon Dec 02, 2019 10:11 pm

It was "upside-down" only relative to the prior implementation. And it was made clear earlier in the thread that you had fixed it being previously upside down. So I think it's all good now. ☺ Thanks for your work on FreeCAD!