Thank you very much for the posted link to the created macro.
It was completely new for me, that you apparently already started im May working on a solution for thread representation in TD.
I tried the macro on a simple cube with tapped hole and as far as I understood the functionality, according to current state it creates the correct thread representation according to ISO 6410-1 in TD for the top view
. I think this is a very huge and considerable progress in solving the thread representation issue in TD.
The thread representation in the cross section is not developed yet. Especially the representation of a partial thread will be a challenge for development.
Unfortunately I read also in the TD forum about the absence of Developer Wandererfan absence for the foreseeable future https://forum.freecadweb.org/viewtopic.php?f=8&t=51233
In your last thread posting you wrote
reox wrote: ↑
Wed Oct 21, 2020 4:57 pm
however the hard part is still to link the information from PD into TD...
I also believe that it will not be easy, although I cannot really evaluate this. My current Python programming skills are rather poor.
But that need not to remain so...
Maybe for a final stage the implementation in PartDesign workbench feature hole https://wiki.freecadweb.org/PartDesign_Hole
will be a very distant goal...
How could one perhaps support you and your efforts?