Basic TechDraw Tutorial

Discussions about the development of the TechDraw workbench
Post Reply
User avatar
wandererfan
Posts: 4078
Joined: Tue Nov 06, 2012 5:42 pm

Basic TechDraw Tutorial

Postby wandererfan » Fri Aug 03, 2018 5:53 pm

A tutorial covering the basics of using the TechDraw_Module is located here:Basic_TechDraw_Tutorial
Top
User avatar
wandererfan
Posts: 4078
Joined: Tue Nov 06, 2012 5:42 pm

Re: Basic TechDraw Tutorial

Postby wandererfan » Fri Aug 03, 2018 6:03 pm

If a moderator reads this, could you please pin this topic?

Thanks,
wf
Top
openBrain
Posts: 5188
Joined: Fri Nov 09, 2018 5:38 pm

Re: Basic TechDraw Tutorial

Postby openBrain » Fri Oct 04, 2019 5:46 pm

wandererfan wrote: ↑
Fri Aug 03, 2018 6:03 pm
 If a moderator reads this, could you please pin this topic?
Better use the "Report" icon on your OP so you're sure a mod will get a message. ;)
Top
User avatar
Tamirov.ru
Posts: 89
Joined: Thu Feb 07, 2019 3:21 pm
Contact:
Contact Tamirov.ru

Re: Basic TechDraw Tutorial

Postby Tamirov.ru » Thu Dec 26, 2019 11:12 pm

Thank you guys for TechDraw workbench!
I can't find clear info.. Could someone clearly explain: what is "XDirection" in View or in ProjectionGroup?
Частный вебмастер, разработка сайтов, продвижение сайтов.
Top
User avatar
wandererfan
Posts: 4078
Joined: Tue Nov 06, 2012 5:42 pm

Re: Basic TechDraw Tutorial

Postby wandererfan » Sat Dec 28, 2019 2:26 am

Tamirov.ru wrote: ↑
Thu Dec 26, 2019 11:12 pm
 Thank you guys for TechDraw workbench!
I can't find clear info.. Could someone clearly explain: what is "XDirection" in View or in ProjectionGroup?
Answers here - https://forum.freecadweb.org/viewtopic. ... 83#p356367
Top
Post Reply
Powered by phpBB® Forum Software © phpBB Limited