Broken View

Discussions about the development of the TechDraw workbench
mokkamamba
Posts: 2
Joined: Tue Nov 12, 2019 5:52 pm

Broken View

Postby mokkamamba » Tue Nov 12, 2019 6:17 pm

Hello,

Recently started using freecad, i have a question about the techdraw module however.
I'd like tu use a broken view in a drawing for dimensioning a long however smal view, can't find out if there is a way to achieve this.

Greetings
User avatar
wandererfan
Posts: 3160
Joined: Tue Nov 06, 2012 5:42 pm

Re: Broken View

Postby wandererfan » Thu Nov 14, 2019 4:47 pm

mokkamamba wrote:
Tue Nov 12, 2019 6:17 pm
Recently started using freecad, i have a question about the techdraw module however.
I'd like tu use a broken view in a drawing for dimensioning a long however smal view, can't find out if there is a way to achieve this.
issue #3011. It has been on the list for some time, but hasn't made it to the top yet.
mokkamamba
Posts: 2
Joined: Tue Nov 12, 2019 5:52 pm

Re: Broken View

Postby mokkamamba » Thu Nov 14, 2019 5:25 pm

OK
Thanks