Export of hatched section views

Discussions about the development of the TechDraw workbench
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Post Reply
HelloWorldXD
Posts: 33
Joined: Wed Jun 12, 2019 10:41 am

Export of hatched section views

Post by HelloWorldXD »

Hello

is there a way that i can export a dxf with the hatch pattern.
The causes of this are as follows:
  • Tech Draw is nice but it took a lot of time to make technical drawings
    Technical Drawings for Assemblys not quite there where it should be
    GD&T to create is very time consuming
But because the 3D features of FreeCad are great i would like to make the models/assemblys in freecad and export the DXF File to make the finish drawings in another CAD Programm.
I tried to make this workflow with exporting Stp Files and make the drawing in a comercial Cad System but the problem is that when some changes are made the whole drawing work must be done again. With exporting a dxf file the dimensions are still there and i can make the rough drawings in techdraw and finish it in for example TurboCad without to make the basic dimension drawings again when the model has changed a little bit.

thanks
HelloWorldXD
Posts: 33
Joined: Wed Jun 12, 2019 10:41 am

Re: Export of hatched section views

Post by HelloWorldXD »

is there no way :lol:
Post Reply