Yes, it is. I would like TechDraw to support a dimensioning solution like GD&T workbench and/or Draft Dimensions eventually.
Topological naming problem and TechDraw
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
- wandererfan
- Veteran
- Posts: 6309
- Joined: Tue Nov 06, 2012 5:42 pm
- Contact:
Re: Topological naming problem and TechDraw
Problematic that i am not a programmer, just a user and only make suggestions.
Greetings
user1234
Greetings
user1234
Re: Topological naming problem and TechDraw
+1 Like this idea very much....-alex- wrote: ↑Tue Jan 11, 2022 11:10 pmyes it is, but without doing the job twice, then with no cluttering of tree view.wandererfan wrote: ↑Tue Jan 11, 2022 3:00 pm This is a bit like the intent of Landmark Dimension - base the measurement on known, fixed points.
Lets continue this discussion here if you want.
BTW: Nice to see you back wandererfan